Flyline Maintenance

Routinely Maintaining Flylines Can Add a Few Extra Years of Useful Life 3 Steps to Fresh Lines

It pays to clean your flyline after every 3-5 usages or when you've fished particularly muddy dirty weedy or mossy water, I just had to retire a flyline I purchased in 1997 and have used consistently for much of my flyfishing over the years. I estimate the line has seen over 150 outings. But I wouldn't have had such good luck with the line had I not taken care of it.

How To Tell if a Flyline Requires Cleaning:
It's not too difficult to tell if your line needs cleaning, look for these clues: You feel micro-grit on the line as you strip it in. For floating line, the first 10 feet or few meters of line doesn't float any longer. The line retains coil memory. The line has small cracks. The line feels brittle. If the latter two observations above are noticed, the bad news is that the line is on its last legs of life. The good news is a cleaning and re-invigoration of the line may add another season of use before you have to replace the line.

Cleaning a Fly Line:
Materials are simple and your workspace can be as simple as the kitchen sink.
Materials: Mild detergent
Clean rag
Flyline dressing (discussion on this topic below)
Line winder (optional)
Cleaning a flyline only takes about 1/2 hour of your time. It's time well invested in preparation for your next few flyfishing trips.

STEP 1 - Soaking:
Draw about a gallon or a few litres of WARM water in a large bowl. Add just a few drops of detergent. Don't overdo it! All you need is enough to make a few bubbles and help loosen debris. Too much soap will leave a film on the flyline which may help it sink. (not good
for floating lines!).
Strip out all the flyline IN LOOSE coils in the bowl, ensuring each coil lies on top of the previous. This will help prevent the line from knotting up as it is cleaned in the next step. Allow the line to soak until the water becomes tepid; about 15-30 minutes or so.
Stretching the line is an important step in cleaning it. Stretching the line once in a while helps maintain its suppleness and prevent line coil memory.

STEP 2 - Cleaning:
Taking a clean, moistened rag in one hand, draw the flyline from the sink through the rag.
Apply mild pressure with the hand holding the rag to ensure the line is being "stripped" of all the debris and dirt. You'll know if you have enough pressure by hearing the line "sqweek" through your hands. LOOSELY coil the line on the floor (good idea to put down a clean towel to lay it on) at your feet in preparation for dressing the line with conditioner and allowing the line to dry for a few moments. TIP: as you draw line through the rag, stretch each arm's-length section as you would a leader, to straighten out the coils that have built up. Loose coils of line prevent knotting and tangling.

STEP 3 - Dressing:
Using a line winder, if you have one, makes applying line conditioner easier, but is not necessary.
Taking another dedicated rag used for applying line conditioner, soak the rag with conditioner.
As the line is wound on the winder, apply the line conditioner in the same manner as the line is cleaned in the step above, Don't be afraid to be generous with the line conditioner; it's the stuff
that will help protect the line in future uses.

Check with the salesman in the shop that the flyline dressing/conditioner is safe for use on your line. Silicon based products are the best bet.

From Napier Anglers July Newsletter.